Skip to main content

Integrations

Set Up Wiz Connector for Illumio

Note

Before you set up the Wiz Connector, create a Wiz service account within the Wiz application. See Add a Wiz Service Account.

  1. Log into Illumio Console, navigate to the Connector page, and click the Wiz tile.

  2. Click the +Add Wiz Connector button. The button only displays if Wiz has not been onboarded yet.

  3. Fill in the following fields:

    • Authentication URL (obtain this value from the Tenant Info page within Wiz)

    • API URL (obtain this value from the Tenant Info page within Wiz)

    • Client ID (obtain this value from the Wiz service account)

    • Client Secret (obtain this value from the Wiz service account)

  4. Click Save.

After you click Save, Illumio Console starts ingesting data immediately. While Illumio Console is ingesting data, the Connection Status field shows Onboarding. After it has ingested the vulnerability data from Wiz, the status changes to Success.

If adding the Wiz Connector fails, the Connector page displays a red warning banner above the Connection Status pane and lists the reason for the connection failure.

The connection may have failed for the following reasons:

  • The Authentication URL or API URL has changed. If so, obtain the correct URL from the Tenant Info page within Wiz.

  • The Client ID or Client Secret was incorrect.